ADPG service management via ADCM

Elena Kostyuchenko

The ADCM UI provides actions to manage the Arenadata Postgres (ADPG) service. The actions are listed in the table below.

Action Description

Add/Remove components

Running this action opens the component-host mapping interface where you can add, remove, and distribute ADPG components

Check ADPG

Runs service-specific tests to check the health of the service and its components

Restart ADPG

Restarts the service. When you run this action, the option Apply configs from ADCM is available. If it is set to true, all service configurations defined in ADCM settings will be applied during the service restart. Otherwise, the service restarts without applying configurations from ADCM

Remove

Removes the service from the cluster. This action should be used to remove already installed services. Whereas the delete control can be used to remove a non-mapped service (a service which components have not been distributed among cluster hosts)

Start ADPG

Starts the service. When you run this action, the option Apply configs from ADCM is available. If it is set to true, all service configurations defined in ADCM settings will be applied on the service startup. Otherwise, the service starts without applying configurations from ADCM

Stop ADPG

Stops the service

Found a mistake? Seleсt text and press Ctrl+Enter to report it