Network requirements

The network requirements for ADET installation are listed below:

  • All cluster hosts should have known IP addresses, fully qualified domain names (FQDN), and the ability to communicate with each other at the required speeds.

  • ping access to any cluster host (ICMP) should be provided.

  • There should be no firewall or other software that blocks or slows down the traffic (firewalld, iptables, ufw, etc.). If deactivation of such software is not possible, then add the ports used by ADET services to the firewall exception list using the table below.

When identifying port numbers, keep in mind the following rules:

  • SSL mode. HTTP Mirror and Grafana use different default ports depending on whether SSL is enabled or disabled. Only add to your firewall exception list the ports that correspond to your SSL mode.

  • Custom ports. If you modified the default ports (for example, during ADET installation in ADCM), use your custom values instead of the values specified in the table below.

NOTE

Each port refers to the host where a specific service is installed.

ADET ports
Service Port Purpose

Common

22

TCP port for SSH connections to the ADET host

Docker Registry

443

TCP port for Docker Registry to download container images. This value can be changed either via the HTTPS port setting of Docker Registry or via the Manage SSL ADET cluster action

HTTP Mirror

81

TCP port (HTTP) to access ADET repositories on a dedicated ADET host during offline installation. This value can be changed via the HTTP port setting of HTTP Mirror

8443

TCP port (HTTPS) to access ADET repositories on a dedicated ADET host during offline installation. This value can be changed via the Manage SSL ADET cluster action

Grafana

3000

TCP port to access the Grafana web interface via HTTP. This value can be changed via the Port setting of Grafana

3003

TCP port to access the Grafana web interface via HTTPS. This value can be changed via the Manage SSL ADET cluster action

Graphite

80

TCP port to access the Graphite web interface. This value can be changed via the Web-interface TCP port setting of Graphite

2015

TCP port for receiving metrics from Diamond agents via Carbon Plaintext Protocol. This value can be changed via the Metrics receiver TCP port setting of Graphite

2016

UDP port for receiving metrics from Diamond agents via Carbon Plaintext Protocol. This value can be changed via the Metrics receiver UDP port setting of Graphite

Found a mistake? Seleсt text and press Ctrl+Enter to report it