Service actions
This article describes the basic steps available at the service layer for ADSCC in the ADCM interface.
To perform an action with services, on the CLUSTERS tab, click on the line with the cluster and in the cluster menu that opens, go to the Services page.
For the ADS Command Center service, ADCM provides:
-
Name, Version, State — columns displaying information about the service;
-
Status, Actions, Import, Config — columns with interactive interface elements (icons).
Service Information
The columns display the following information about the service:
-
Name — service name.
-
Version — service version number.
-
State — the current state of the service (created, installed, etc.).
Working with interactive interface elements in the service
Working with interactive elements in the service occurs by clicking on the element (icon).
On the JOBS tab, you can view the process of performing some actions in the service. Also on the JOBS tab, you can analyze errors if they occur.
To view the results of an action, go to JOBS and click on the name of the corresponding action or on its component.
Next, the page with the results of the action becomes available for viewing, where you can analyze errors if they occur.
Status
When you click on the Status icon, you go to the Status service menu page, which shows the statuses of all service components on the hosts.
Actions
When you click on the Actions icon, the drop-down list offers actions for working with the service.
-
The Check action checks the health of the service.
After selection, you must confirm the action by clicking Run.
Action confirmationIn the ADS Command Center, Check checks the availability of the service on the port and the status of the service.
-
The Restart action stops and then starts the service.
After selection, you must confirm the action by clicking Run.
Action confirmation -
The Start action starts the service.
After selection, you must confirm the action by clicking Run.
Action confirmation -
The Stop action stops the service.
After selection, you must confirm the action by clicking Run.
Action confirmation
Import
When you click on the Import icon, you go to the Import service menu page, on which you set the import of components for integrating the service with other clusters installed in ADCM (Enterprise Tools, Monitoring).
In an ADSCC cluster, there is no service layer import.
Config
When you click on the Config icon, you go to the Configuration service menu page. Service configuration parameters are described in the article ADSCC configuration parameters.
